In process, the surface accuracy is affected by motion parameters such as discharging current capacity and current impulse width.

在加工过程中，加工表面精度自然受到加工参数的影响，其中包括放电电流能量、电流脉冲宽度等的影响。

The charging and discharging currents are controlled by the current flowing into IIN, and are modulated by the voltages applied to FADJ and DADJ.

充放电的电流是由流入IIN端的电流来控制的，并由加到FADJ和DADJ上的电压调制。

Low voltage charging or discharging may also cause deterioration of capacitor such as shorting and open due to sudden charging and discharging current.

即使是低电压充放电，也可能产生大的瞬间充放电电流，这可能会导致电容器性能的损害，比如说短路或开路。

The phenomenon of discharging in twice of underwater wire exploding is discovered by investigating the time characteristics of pulsed discharging current and voltage.

通过测量水中铜丝电爆炸的电流、电压波形发现水中高压放电存在着二次放电现象。

Through the experiments with quickly wire cut of electric discharge machines, this paper analyzes and studied the influence regulation of the discharging current to the surf...

通过在快走丝线切割加工机床上进行多次加工实验，本文研究分析了放电电流对线切割加工表面粗糙度的影响规律。